3c33ddb1

7.4.5. Replacement of covers of hinges of equal angular speeds

PERFORMANCE ORDER
1. Remove a power shaft. Remove the hinge of equal angular speeds from a power shaft. If replacement of two protective covers is necessary, remove only one hinge of equal angular speeds and a quencher of tortional fluctuations from a power shaft.
2. Remove collars of fastening of protective covers and shift a protective cover from a power shaft.
3. Clean old lubricant from the hinge of equal angular speeds and fill the hinge with new lubricant.
4. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in flutes of a power shaft. The internal flange of a protective cover has to be at distance of 135 mm from the end of a power shaft. If on driving to a shaft there are two flutes, the internal flange of a protective cover needs to be established at distance 123 mm from the end of a power shaft.
5. Fill with fresh lubricant the hinge of equal angular speeds.
6. Install the hinge of equal angular speeds with a new lock ring on a power shaft. At the same time the lock ring has to be recorded accurately in a flute of a power shaft.
7. Establish a collar of fastening of a protective cover.
8. Install a protective cover on the hinge of equal angular speeds, then let out the air from under a protective cover.
9. Fix a protective cover by new collars.
10. Install a power shaft in the car.