3c33ddb1

3.4.1. Introduction

The engine with a working volume of 1994 cm3, with 4 cylinders and 16 valves, with the top arrangement of the camshaft, installed cross with the transmission on the left side of the engine. The bent shaft leans on 5 radical bearings. The axial side play of a bent shaft is regulated by the persistent half rings located from two parties of the N3 bearing. The camshaft is put in action by a chain from a bent shaft.

Lubricant of the engine is produced under pressure created by the oil pump which is given from the right end of a bent shaft. Oil is sucked in via the mesh filter located in an oil receiver and then comes via the external installed filter to canals of the block of cylinders. Bearings of the lower head of a rod are supplied with oil through internal drilling in a bent shaft. Cams of the camshaft and valves are oiled sprayed as well as all other mobile details of the engine.

Repair operations which can be carried out on the engine installed in the car

The following operations which can be carried out, without removing the engine from the car:

– to check compression pressure;
– removal and installation of a cover of a head of the block of cylinders;
– removal and installation of a casing of a chain;
– removal and installation of a chain;
– removal and installation of a natyazhitel of a chain;
– removal and installation of the camshaft and pushers;
– removal and installation of a head of the block of cylinders;
– removal and installation of pistons and rods;
– removal and installation of the oil pallet;
– removal and installation of the oil pump;
– removal and installation of the oil heater;
– replacement of sealing rings of a bent shaft;
– replacement of support of the power unit;
– removal and installation of a flywheel.