3c33ddb1

3.2.5. Cover of a head of the block of cylinders

Removal
PERFORMANCE ORDER
Engines of 1,6 l
1. Remove the top section of an inlet collector.
2. Remove tips of high-voltage wires from spark plugs.
3. Release collars and disconnect hoses of ventilation of a case of the engine (are specified by shooters) since the left forward end of a cover of a head of the block of cylinders.
4. Evenly and gradually unscrew bolts of fastening of a cover of a head of the block of cylinders.
5. Uncover a head of the block of cylinders and check a condition of consolidations and washers under bolts of fastening of a head.
L engines 1,8 and 2,0
6. Weaken collars and disconnect hoses of ventilation of a case from a back part of a cover of a head of the block of cylinders (junctions of hoses are specified by shooters).
7. Unscrew screws and uncover spark plugs. Remove high-voltage wires from spark plugs.
8. Disconnect the electric socket from the camshaft sensor.
9. Evenly and gradually unscrew screws of fastening of a cover of a head of the block of cylinders.
10. Uncover a head of the block of cylinders and check a condition of sealing rings in nests under fastening bolts.

Installation

PERFORMANCE ORDER
1. Check that a cover of a head and a surface of a head of the block of cylinders pure and dry. Establish laying in a head cover.
2. Establish ring consolidations in nests under bolts.
3. Apply a thin film of sealant on a cover of forward and back bearings of the camshaft.
4. Establish a cover of a head of the block of cylinders and tighten bolts. You make tightening of bolts from the center for a spiral.
5. Connect hoses of ventilation of a case and fix them by collars. Establish high-voltage wires on spark plugs.
6. Establish the top section of an inlet collector.
L engines 1,8 and 2,0
7. Installation of a cover of a head is made in the same way, as well as for the engine of 1,6 l.