3c33ddb1

3.1.16. Drive flywheel / plate

Removal

PERFORMANCE ORDER
Mechanical transmission

Prevention

For fastening of a flywheel it is necessary to use only new bolts.


1. Remove the transmission. Remove couplings from a flywheel.
2. Record a flywheel from a provorachivaniye, having established a clamp on a gear wreath of a flywheel. Apply combination tags on a flywheel and a bent shaft.
3. Unscrew bolts of fastening and remove a flywheel.
Automatic transmission
4. Remove the transmission and a plate of the drive, noting that there is a preservation plate established between bolts of fastening and a plate of the drive.

Check

PERFORMANCE ORDER
1. On models with the mechanical transmission check a flywheel for wear from coupling and a condition of teeths of a gear wreath.
2. On models with the automatic transmission check a condition of the drive of the hydrotransformer and a gear wreath.

Installation

PERFORMANCE ORDER
Mechanical transmission
1. Clear the interfaced surfaces of a flywheel and a bent shaft.
2. Establish a flywheel according to earlier put tags and screw up fastening bolts.
3. Record a flywheel from a provorachivaniye.
4. Finally tighten bolts of fastening of a flywheel.
5. Tighten bolts of fastening of a flywheel on the required corner.
6. Establish coupling and the transmission.
Automatic transmission
7. Clear the interfaced surfaces of a plate of the drive and a bent shaft.
8. Apply the means interfering unscrewing of bolts on a carving of bolts of fastening of a plate of the drive, establish a drive plate according to early the made tags and screw up fastening bolts.
9. Install the transmission.